[General] Refresh Command Card

[Cokemonkey11]

Hello,

I use "clear selection" and "select unit" in my map, and I notice that about 1 in 30 times this happens:

The command card doesn't fill up. In game you can deselect and reselect the unit to reset the command card, but is there a native that can "reset" the command card?

Regards,

 

[PurgeandFire]

No native, but adding/removing an ability should do the trick, or forcing a selection, or killing a unit.
http://www.thehelper.net/threads/resettooltips.124830/

Adding/removing a dummy ability is the easiest method. I'm not sure if it will fix your command card issue (I only used it to update tooltips), but I believe it is a similar problem.

 

[Cokemonkey11]

Thanks, I'll try that out and see if it doesn't work.

Edit: For anyone reading this thread, adding/removing ability doesn't fix the problem unfortunately. It's probably an engine limitation.

This problem is therefore unsolved.