JassHelper not running after "Save Map as..."

[Gismo359]

Every time I use "Save Map as..." JassHelper refuses to run on the newly created save. The original map compiles correctly - no errors, runs normally in warcraft, whilst when editing the new one - JassHelper is completely non-existent, not even a progress bar at the end of the save process. This happens even if I dont make ANY changes to the map.

I've tried using JNGP 5d and JNGP 2.0 and still the same problem.
When I was using them on my other computer they were working correctly and as they should.
The same problem occurs if I just Copy-Paste the map file (no matter where it has been pasted).

I should also note that after opening one of these maps in JNGP, all other have the same problem, whereas when I close JNGP, open it again and open a working map - everything is fine.

EDIT: To clarify, the "JassHelper" menu at the top of the editor is there, along with its contents.

 

[Wietlol]

Save as doesn't apply JassHelper correclty indeed.
I got the same problem, but you can just save your map the regular way after saving as.

 

[Vinz]

Indeed, though it might take time if the map is big.

 

[Gismo359]

What I meant is that the map refuses to apply JassHelper no matter how I save it, not just the "Save as".

 

[sonofjay]

JassHelper tab -> Enable Cohadar/Vexorian's JassHelper

You sure you selected any one this two? There should be a check beside it if you did.

 

[Gismo359]

Yes I did. JassHelper is enabled and I tried both Cohadars and Vexorians but neither one made a difference.

EDIT: Okay, after restarting the computer for the 3-4th time it seems to work on some maps but not on other. Istll cant figure out the reason, though. The maps can be the same, yet only one of them works.

 

[Wietlol]

Do your maps actually have large JASS/vJASS code in it?
If they don't then JassHelper is too fast and there will be no popup or it has nothing to do and doesn't come.

 

[Gismo359]

They have a decent amount of code, although that shouldnt matter. Saving a map without any triggers should also show the progress window. Also, some maps have little to no changes and they still dont save properly.

 

[Wietlol]

Try re-installing newgen.
I had to re-install 6 times and recover it 3 times to actually get vJASS installed.
I don't know how or why but it just did.

 

[Gismo359]

Well, its better this time. The maps that couldnt be saved before still dont work, but thankfully I found out about the problem when I hadnt made any changes. I guess this can be marked as solved/closed now.

 

[Vinz]

If they don't then JassHelper is too fast and there will be no popup or it has nothing to do and doesn't come.

Even melee maps have a a progress bar of at least 0.75s though.