• Listen to a special audio message from Bill Roper to the Hive Workshop community (Bill is a former Vice President of Blizzard Entertainment, Producer, Designer, Musician, Voice Actor) 🔗Click here to hear his message!
  • Read Evilhog's interview with Gregory Alper, the original composer of the music for WarCraft: Orcs & Humans 🔗Click here to read the full interview.

[SD/Modeling] Raise Height of Model?

Status
Not open for further replies.
Level 21
Joined
Mar 16, 2008
Messages
955
Would it be a lot of work to raise this model?


I want to raise it so it will sit on its perch, which is this model: Owl perch

I can't figure out how to do this myself without a lot of work. Would this be something quick to do if you knew how?

Thanks.
 
Level 21
Joined
Mar 16, 2008
Messages
955
I've been tinkering around with adjusting unit height and it seems to work. It just supposed to be a 'prestige trophy' for beating the game on a previous difficulty so I was worried this would cause unforeseen problems. I'll use this method and see if it causes any bugs. Thanks for the suggestion.
 
Level 23
Joined
Dec 4, 2007
Messages
1,557
That's very easy to do in magos or retera's model studio.
Just increase z axis
Clipboard01.jpg
 
Status
Not open for further replies.
Top