• Listen to a special audio message from Bill Roper to the Hive Workshop community (Bill is a former Vice President of Blizzard Entertainment, Producer, Designer, Musician, Voice Actor) 🔗Click here to hear his message!
  • Read Evilhog's interview with Gregory Alper, the original composer of the music for WarCraft: Orcs & Humans 🔗Click here to read the full interview.
  • 💡 We're thrilled to announce that our upcoming texturing contest is in the works, and we're eager to hear your suggestions! Please take this opportunity to share your ideas in this theme discussion thread for the Texturing Contest #34!
  • 🏆 Hive's 7th HD Modeling Contest: Icecrown Creature is now open! The frozen wastes of Icecrown are home to some of Azeroth’s most terrifying and resilient creatures. For this contest, your challenge is to design and model a HD 3D monster that embodies the cold, undead, and sinister essence of Icecrown! 📅 Submissions close on April 13, 2025. Don't miss this opportunity to let your creativity shine! Enter now and show us your frozen masterpiece! 🔗 Click here to enter!

[General] Props in Air!

Status
Not open for further replies.
Level 8
Joined
Dec 11, 2012
Messages
412
So, I found out that there are some props/doddads in air. Whenever I move them, they go down. I wanna know how people keep their props in air... Mid air. Is it a function or another UI?

EDIT: Btw, how do people squish their props and doddads in the ground, so, like half of it is underground.
 
Level 8
Joined
Dec 11, 2012
Messages
412
PgUp doesn't eleveta it, it extends its corners and makes them huge. I need them to be attached like a bridge on platform, but attached as props. There is land, sea, then land. I need a doddads/bridge to be up beetwen. Usually, its not.

This only squishes them, I need them to be half underground. Like an npc without legs.
 
Level 29
Joined
Sep 26, 2009
Messages
2,564
It's just like CakeMaster wrote.

[PgUp] / [PgDown] for scaling the object on Z axis (= scaling its height)
[CTRL] + [PgUp] / [CTRL] + [PgDown] for moving the object on Z axis (= moving up or down).

You can also change the key binding in File -> Configure Controls.
 
Status
Not open for further replies.
Top