Move Trigger problem (units stop moving)

[hi.gin.tonic]

• xx2
  • Events
    • Time - Every 7.00 seconds of game time
  • Conditions
  • Actions
    • Set Temp_UnitGroup[1] = (Units in (Playable map area))
    • Unit Group - Pick every unit in Temp_UnitGroup[1] and do (Actions)
      • Loop - Actions
        • If (All Conditions are True) then do (Then Actions) else do (Else Actions)
          • If - Conditions
            • ((Picked unit) is A Hero) Equal to True
          • Then - Actions
            • If (All Conditions are True) then do (Then Actions) else do (Else Actions)
              • If - Conditions
                • Or - Any (Conditions) are true
                  • Conditions
                    • (Owner of (Picked unit)) Equal to Player 1 (Red)
                    • (Owner of (Picked unit)) Equal to Player 2 (Blue)
                    • (Owner of (Picked unit)) Equal to Player 3 (Teal)
                    • (Owner of (Picked unit)) Equal to Player 4 (Purple)
              • Then - Actions
                • Unit - Order (Picked unit) to Attack-Move To (Center of LB skull <gen>)
                • Custom script: call DestroyGroup(udg_Temp_UnitGroup[1])
              • Else - Actions
                • Unit - Order (Picked unit) to Attack-Move To (Center of DG skull <gen>)
                • Custom script: call DestroyGroup(udg_Temp_UnitGroup[1])
          • Else - Actions
            • Do nothing

The trigger works fine when the amount of units is relatively low, but when there are units above 30 a few stop obeying orders at around 80 it gets pretty bad they group up and stand around and at 165 almost nothing moves.
i was thinking about adding regions and triggering units to attack move to the next region but when the units kill something/cast a spell they seem to forget that they where supposed to attack move to the next region.

 

[baassee]

they dont forget their orders, it's just massive lagg, make smaller groups and refresh them not and the same time

 

[hi.gin.tonic]

Thanks it works better now.