Help

[emitrin]

I dont know if this is possible.

Upon attacking a unit you add a bleed charge stacking 10 times dealing 10 damage per stack for 3 seconds. So if you attack 10 times you deal 100 damage per second for 3 seconds. whenever the unit stops taking damage the bleeds reset.

 

[TwoVenomous]

I dont know if this is possible.

Upon attacking a unit you add a bleed charge stacking 10 times dealing 10 damage per stack for 3 seconds. So if you attack 10 times you deal 100 damage per second for 3 seconds. whenever the unit stops taking damage the bleeds reset.

Yes, It's possible..

 

[emitrin]

This doesnt do damage over time. Just a single stacking strike. Which is good to know. I am looking for a stacking shadow strike basically. If that gives you a better idea.

Ideally the combo spells would be. This ability which puts a buff stacking up to 10 times dealing 10 additional damage per second per stack for 3 seconds.

An ability that slows by 5% per bleed stack.

An ability that deals 20 damage per stack instantly resetting the stacks.

An ability that silences a target and adds bleed stacks. Something like doom im sure. but upon killing it gives bonus gold not a demon.

 

[TwoVenomous]

This doesnt do damage over time. Just a single stacking strike. Which is good to know. I am looking for a stacking shadow strike basically. If that gives you a better idea.

The best i could do

 

[Maker]

@Two Venoms
The skill is otherwise ok, but setting the bleedcount to 0 if it is 10 could use an improvement, as I believe it should stay at 10 if the unit is hit again during the bleed duration.

You could set the unit's custom value to cv. Then detect when that dummy unit type dies, give it 3 second expiration time.

set cv = custom value of dying unit
if ability level of bleed for dying unit == bleed[cv] then
--set bleed[cv] == 0
endif

Remember to set UnitIndexerEnabled to false before setting the custom value of the dummy, and set it to true right after that.

Remove invulnerability from the unit, it has locust. Set death type to Can't raise, does not decay. Set Death time to 0.

 

[TwoVenomous]

You could set the unit's custom value to cv. Then detect when that dummy unit type dies, give it 3 second expiration time.

set cv = custom value of dying unit
if ability level of bleed for dying unit == bleed[cv] then
--set bleed[cv] == 0
endif

what is this for ?

 

[Maker]

When a unit dies, there has been 3 seconds (the buff's duration) from the hit. The integer comparison checks if it was the last hit that was done. And I now realized it will bug when stack count is 10.

Fixed.

 

[emitrin]

close enough to work with