• Listen to a special audio message from Bill Roper to the Hive Workshop community (Bill is a former Vice President of Blizzard Entertainment, Producer, Designer, Musician, Voice Actor) 🔗Click here to hear his message!
  • Read Evilhog's interview with Gregory Alper, the original composer of the music for WarCraft: Orcs & Humans 🔗Click here to read the full interview.

Getting the Most out of my Connection

Status
Not open for further replies.
Level 18
Joined
May 27, 2007
Messages
1,689
Im guessing, that this would be the right forum to ask, how do I increase my download speed, for anything that I download, for example when I use limewire, load videos off the internet (Youtube), Internet Explorer downloads, etc.. I know my computer can download much faster than it does, becuz when I dl something with the IE it starts out at a desirable rate, but then slows to around 30 KB/S quite rapidly. Is there anything that can be done to juice my connection for all the KB its got?
 
Level 21
Joined
Aug 3, 2004
Messages
710
You know... When you click a link, it immediately starts downloading, then once you select a destination, it'll show the download dialog, that means, depending on how slow you were at choosing a destination, i might've downloaded like 1mb, and it thinks it did it in a few seconds, hence it shows a high speed, which is fake.
 
Level 25
Joined
May 31, 2007
Messages
1,443
you know that Microsoft uses 20% of your Bandwidth for his updates. (if you use WINDOWS XP PRO):thumbs_down:
ok how to take back 20% of your Bandwidth from Windows XP

Click Start / Run

Type: gpedit.msc
This opens the group policy editor. Then go to:

Local Computer Policy / Computer Configuration / Administrative Templates / Network / QOS Packet Scheduler / Limit Reservable Bandwidth

Double click on Limit Reservable bandwidth. It will say it is not configured, but the truth is under the ‘Explain’ tab:

“By default, the Packet Scheduler limits the system to 20 percent of the bandwidth of a connection, but you can use this setting to override the default.”

So the trick is to ENABLE reservable bandwidth, then set it to ZERO. This will allow the system to reserve nothing, rather than the default 20%. :wink:
 
Level 25
Joined
May 31, 2007
Messages
1,443
Here's something for broadband people that will really speed Firefox up:

1. Type "about:config" into the address bar and hit return. Scroll down and look for the following entries:

network.http.pipelining
network.http.proxy.pipelining
network.http.pipelining.maxrequests

Normally the browser will make one request to a web page at a time. When you enable pipelining it will make several at once, which really speeds up page loading.

2. Alter the entries as follows:

Set "network.http.pipelining" to "true"

Set "network.http.proxy.pipelining" to "true"

Set "network.http.pipelining.maxrequests" to some number like 30. This means it will make 30 requests at once.

3. Lastly right-click anywhere and select New-> Integer. Name it "nglayout.initialpaint.delay" and set its value to "0". This value is the amount of time the browser waits before it acts on information it receives.

If you're using a broadband connection you'll load pages MUCH faster now!
 
Status
Not open for further replies.
Top