Nuke Strike: Removing the nuke requirement

[Tylon]

I'm trying to create an ability based on Nuclear Strike, and I need to remove the requirement of having a nuke ready in the Ghost Academy. I've looked around in the data editor but haven't find a solution... Have anyone else found a way to do this?

EDIT: So after two days I found out how to do it myself... ;P

This is what you have to do:
1. Go to the Nuclear Strike ability (or the one you have copied from).
2. Double-click on the (none) - Commands + value.
3. Select the Execute command and then click the little red cross at the bottom to remove its requirements. Press OK.
4. Double-click on the (none) - Effect value.
5. Change the value to Ghost - Nuke (Persistent). Press OK.
6. Now, go to the Ghost - Nuke (Persistent) under Effects.
7. Double-click on the Effects - Effect - Final.
8. Change the value to (None). Press OK.

 

[Mepper]

Hey! I haven't tested it, but I think going to Ability -> Requirement -> Remove Requirement Node should work, as shown in the picture.


Picture

EDIT: Picture was too big, so I posted it as a link.

 

[TGhostdk]

Under the ability in the data editor, modfiy the Commands + field and then click the 'Execute' command and hit the little red 'Remove Requirement' X in the bottom right hand corner.

 

[thisruoy]

That doesnt do much, you still need to remove the requirement to train a nuke at Acacdemy

 

[Dr Super Good]

You have to modify the actual requirements, its a whole data type.
Find the nuke related requirement data and alter the logic driving them so it is true at all times.

 

[gosho]

can u post example map

 

[Tylon]

After some experimenting I finally found out how to launch the nuclear strike without the requirements.

This is what you have to do:
1. Go to the Nuclear Strike ability (or the one you have copied from).
2. Double-click on the (none) - Commands + value.
3. Select the Execute command and then click the little red cross at the bottom to remove its requirements. Press OK.
4. Double-click on the (none) - Effect value.
5. Change the value to Ghost - Nuke (Persistent). Press OK.
6. Now, go to the Ghost - Nuke (Persistent) under Effects.
7. Double-click on the Effects - Effect - Final.
8. Change the value to (None). Press OK.

And that's it! It should now work perfectly! ;P

 

[gosho]

10x man
its working