Invisable Platform On Doodads?

[VampireHeart]

How do you get a invis platforms on another doodad. like in this map for Morph's palaside kit:

 

[Deckboy]

Are you asking how to make the walls walkable?

To do that just:
1)Make a new destructible based one of the bridges
2)Change the model file to the wall model
3)Set pathing to none
4)Check to make sure that the model IS walkable(if not just check the box to make it pathable)
5)Place the model in your map
6)Place pathing blockers on the ground around the model

Hope that helps!

 

[VampireHeart]

thats not what im asking for look in the map.

 

[-JonNny]

I dont know how he made it with these stairs ( i guess its th model)
If i understood u , just look in the doodads and there in the "brides" section IS a invisible plattform doodad. Then just change its height of it in thee editor and u got one
If u didnt want to know that 2 please be more precise

 

[VampireHeart]

hight? where is hight? is it occlusion hight. And BTW if you take the platforms off the model it gos down to ground lvl so maby not... :emote_dribble:

 

[-JonNny]

Yes of course the unit will go down then , (at the stairs are no plattforms) but u need them at the rest .
( Im sorry but *height *height *height *height *height ) And to change the height of a Doodad ( Invisible Plattform ) press "CTRL" and one of these two buttons (i dont know their names xD , Picture Up /Down or sth - two buttons right from delete and paste)

 

[Rui]

I think you're asking how to raise the doodads in the air. In that case, press CTRL and then press Page Up to raise, and Page Down to lower.

 

[VampireHeart]

i tried that and still no luck at all... Maby cuz i got a mac?

 

[Dr Super Good]

Make all your wall with destructiables and tick the "Is Walkable" box in the object editor and the WC3 game engine does the rest.

 

[VampireHeart]

yes ive done that but then the model does not stick together.:emote_mad:

 

[Dr Super Good]

You need to remove pathing from the models, so that you can position them freely. Mess around a bit and I am sure you will eventually find a way.

 

[Deckboy]

Just do what I said. . .it works and fixes your problem.

 

[VampireHeart]

have you tested it with all of the wall models(corner/corner rev.)?

 

[Deckboy]

yes. . .

Besides, that's how XXmorpheousXX said to do it