I got inspired by this request here by Homor to make the Bandit Assassin model from Reforged as an SD model. To achieve this I had to swap the head of the acolyte over to the bandit spearthrower, edit the shield's mesh as well as the skirt and then re-map the texture so that the head would share the same texture as the rest of the body. After finishing the modelling I then re-draw the entire texture in freehand. After that was done General Frank was nice enough to clean up the model, integrate the portrait and generally optimise it for use.
My reference image was this one below:
As always give credit to me and General Frank if used and you may edit without permission but if you are going to upload an edit then please seek permission first.
Yep it's one of these grey areas where you could argue about where it should fall but Frank and I agreed it should be in the skins section. The model is just an alternative choice if one wants the full effect similar to my High Elf Archmage skin
🔨 Hive's 3D Viewer has been updated! 🔨 It now supports MDX1100 which should fix a lot of issues when viewing HD models in our 3D Viewer. We encourage you to check it out for yourself and report any issues you find in the Site Discussion board.