• Listen to a special audio message from Bill Roper to the Hive Workshop community (Bill is a former Vice President of Blizzard Entertainment, Producer, Designer, Musician, Voice Actor) 🔗Click here to hear his message!
  • Read Evilhog's interview with Gregory Alper, the original composer of the music for WarCraft: Orcs & Humans 🔗Click here to read the full interview.

Vertex Problems ?

Status
Not open for further replies.
Level 3
Joined
Aug 11, 2016
Messages
32
Hello :)

I tried to make a model using MdlVis and Magos. The model looks good-ish in both programs but when I open the model in the editor / game the vertexes are messed up bad.

So...what causes this problem and how can I resolve it ?

Look at the screenshots below for understanding my problem better.
 

Attachments

  • In Magos Model Editor.jpg
    In Magos Model Editor.jpg
    88.8 KB · Views: 69
  • In MdlVis.jpg
    In MdlVis.jpg
    142 KB · Views: 70
  • IN GAME.jpg
    IN GAME.jpg
    565.5 KB · Views: 51
Level 3
Joined
Aug 11, 2016
Messages
32
I had the same problem with the left hand. I attached it and in-game that thing happened.
The right hand had no problems and I did the same thing.
So...what am I doing wrong ?

Problem Resolved. Thanks GhostWolf.

You made me look at the bone's again ( 5th time ) and I saw that I didn't reattach a vertex ( a small one ) to the bone.
 
Last edited by a moderator:
Status
Not open for further replies.
Top