Underwater Map Help

[Animalpower]

I have created a underwater map. I don't know how to add fog only at the part of the map, not the complete map, I have made triggers for submerging, but I don't know how to make the unit surface, the map will explain further if you check my map and open Trigger Editor\Dive when you click Dive there is a trigger comment to say what you need to do.

I am asking you to make the triggers for surfacing of the unit and make a special-area fog, when it's done, post the Underwater Level map below on a attachment.

 

[Marc Mamales]

i think that is impossible, but dont trust me. im always EPIC FAIL

 

[kleinerhauck]

Marc's right. You could only try to find/make a model which replaces the fog.

 

[Animalpower]

It's not impossible, you should play water war- submerged to see that it is possible.

 

[Bribe]

Set the fog locally for each player, with a periodic timer check if the player's camera is within the "water" zone. Switch the fog as needed.

 

[kleinerhauck]

Set the fog locally for each player, with a periodic timer check if the player's camera is within the "water" zone. Switch the fog as needed.

How do you get the player's camera though?
Doesn't using 'Current Camera' provoke a disc?

 

[Dr Super Good]

Doesn't using 'Current Camera' provoke a disc?

Only if you use it to to alter the game in such a way it falls out of sync. If you use it to check where the camera is and eithor set it to fog or to no fog then it should not as the effect is purly visual.