• Listen to a special audio message from Bill Roper to the Hive Workshop community (Bill is a former Vice President of Blizzard Entertainment, Producer, Designer, Musician, Voice Actor) 🔗Click here to hear his message!
  • Read Evilhog's interview with Gregory Alper, the original composer of the music for WarCraft: Orcs & Humans 🔗Click here to read the full interview.

Raised Cliff issues.

Status
Not open for further replies.
Level 1
Joined
Nov 21, 2017
Messages
1
Hi all.

New to the world editor, and to Hive.
I'm trying to create a waterfall, following a specific guide that mentions using the raise 2 tool twice, and then shallow water on the top layer. However, when I use the shallow water tool, it automatically punches through all cliff to the ground level, leaving a huge crater as opposed to just going through the top layer.

Is it an option I've missed perhaps? the only other things I did on the map was start it with the entire map being shallow water, used the raise ground tool to fill it up, and then leave the water where desired, as a rolling shores tutorial told me to do.

Sorry if this has been asked before, I've unwittingly broken a rule or if it's an utterly stupid question, and thanks in advance.

-Brandon.
 
Status
Not open for further replies.
Top