Problem with Bridge models

[Anknaton]

Hello there... I need some help with some bridges I downloaded... I got some bridges to use in my project... I want to create indestrutible bridge like a struture doodad but walkable, I've seen tutorials here but it didn't really help... They must be destructible? Help Please...

 

[muzzel]

You also can use Bridge-doodads and simulate the pathability with blockers/invisible platforms.

 

[T. D. W.]

Yes, they must be destructible-bridges to make them work as a real bridge, structures won't do the work

@muzzel, i think that's a little hard to make (the height problem when walking on the "simulated bridge")

 

[Vinz]

^Not that hard, I just raised the ground beneath them. (Or use platforms)

@OP simply set HP of bridges to [Shift + Enter] 99999999 so they are 'indestructible'.

 

[Anknaton]

I see... Thanks... But how it works? The "Simulated Bridge"? I can use the invisible platform, fine, but isn't that platform animated (Goes up and down)?

 

[GreeN!X]

Not the elevator doodad. Search for "Invisible Platform" in the doodad palette (It's in the Bridges/Ramps list of doodads) and use ctrl + page up/page down to raise/lower the invisible platform so that you can create/simulate bridges.

 

[Anknaton]

Not the elevator doodad. Search for "Invisible Platform" in the doodad palette (It's in the Bridges/Ramps list of doodads) and use ctrl + page up/page down to raise/lower the invisible platform so that you can create/simulate bridges.

Thanks Hera! That was helpful... Thanks a lot!

 

[Zunariel]

If you hold Strg and pish Picture Up you can set doodads Higher or with Picture down lower. So you can for example put a beer model on a table or in a shelf and you can set invisible platforms higher ^^ it´s not that hard to build a bridge with that.