[Trigger] Disable trigger if attacked or dead

[LegendaryViewer]

Hey guys newbie here I need help with a trigger with my map I was trying to create a timed capture of a unit if a hero enters a region but i need help cancelling the trigger if the heeo is attacked but after a few seconds that the hero is not attacked and enters the region again it activates again. Any help will be acknowleged

sorry about the typos i'm not used to typing on my mobile

 

[Bribe]

So, kind of like standing on one of the altars from the LoL map, Twisted Treeline? Do you have any triggers made, yet?

 

[Arad MNK]

There is a waaaaay similar Spell in the spell section. Check it out.

 

[LegendaryViewer]

So, kind of like standing on one of the altars from the LoL map, Twisted Treeline? Do you have any triggers made, yet?

Exactly lol but a little different anyway here is my trigger.

 

[Bribe]

Ok so you have a work in progress, excellent. By the way, I find this nethod easier than taking a picture:

www.hiveworkshop.com/forums/miscellaneous-tutorials-456/how-easily-post-triggers-163285/

I just woke up, so I'll look into this today.

There is a waaaaay similar Spell in the spell section. Check it out.

I tried searching for it, I could not find any. I found some capture-point systems, but they don't work quite like this.

 

[Wietlol]

What you need is a periodic check that finds out if there are any (or multiple) valid control point takers in the given area.

This means that you would need a boolean array for example and check if the value is false (default).
When a unit takes damage, set it to true, run a timer and set it to false when it expires.

Then every 0.03 to 0.10 seconds of gametime, you pick all units inside the control point and check how many there are of each allied force (allied player group).
If there are multiple forces in there, then you dont change anything, if there is only one force, you can increase their contribution of the control point by either a raw value or a value based on the number of units in there.

There are too many different behaviors of these kind of control points to just give you the way to make it with this few information about it's actual behavior but this structure should work for every single kind of control point.

 

[LegendaryViewer]

What you need is a periodic check that finds out if there are any (or multiple) valid control point takers in the given area.

This means that you would need a boolean array for example and check if the value is false (default).
When a unit takes damage, set it to true, run a timer and set it to false when it expires.

Then every 0.03 to 0.10 seconds of gametime, you pick all units inside the control point and check how many there are of each allied force (allied player group).
If there are multiple forces in there, then you dont change anything, if there is only one force, you can increase their contribution of the control point by either a raw value or a value based on the number of units in there.

There are too many different behaviors of these kind of control points to just give you the way to make it with this few information about it's actual behavior but this structure should work for every single kind of control point.

Thank you I'm new with triggers so I have no Idea what those booleans and arrays are but I will try Thank you again!