cliff y you no go down

[edo494]

I have a little tricky problem, when I create a blizzard cliff(raise tool) it is OK but when I try to lower it it does maximally this:
(Yes I used Extensions of JNGP to edit tiles)

image

with the same map the same thing happens even without JNGP.
Is it possible Ive pressed something that will make it not go down or will it just be like that when I "import" tiles with Extensions?

 

[gorillabull]

what is your map's cliff height? its probably 0 if it wont go down

 

[edo494]

2 well but obviously there is a land lower a I mean that the cliff edges are not going down. But I think it may be something with the Extensions(the Edit Tilesets) because it does the same thing even with normal WE but any other map works just fine

 

[rulerofiron99]

Was there previously water there?

 

[edo494]

I raised the water above the water level but yes the map was generated at cliff level 2 with starting terrain deep water and I raised it to make it not under water but be able to have nice shores etc etc you know

 

[rulerofiron99]

Well that there is your problem!

Try removing the cliffs with shallow/deep water.

 

[edo494]

well, I tried that too still did nothing, made a hope all around it but not within the original edges(the ones that you see are up), i think it has something to do with the fact that I have 16 tilesets well, this limits me a little bit, I have to be carefull or Ill smash ctrl z very often
btw nice collection of systems youve got there

 

[HappyTauren]

Advanced > Adjust Cliff Levels. Bear in mind, however, that this will mess your water.

 

[edo494]

NOW I know what it is actually
If you(at least me) base a map on dungeon and make it be undewater and raise it then when you increase cliff you cant deincrease it as whole, the "edges of it" will keep their height. Now Just to change it and Im done
thx for help anyways