• Listen to a special audio message from Bill Roper to the Hive Workshop community (Bill is a former Vice President of Blizzard Entertainment, Producer, Designer, Musician, Voice Actor) 🔗Click here to hear his message!
  • Read Evilhog's interview with Gregory Alper, the original composer of the music for WarCraft: Orcs & Humans 🔗Click here to read the full interview.

Apply Force on attack

Status
Not open for further replies.
Level 9
Joined
Dec 21, 2006
Messages
490
hi

anyone figured out how to use force on attack? i simple want a unit to knock back if being attacked by a weapon.

i know how to do with abilities but somehow i cannot figure out how to in weapons. the weapon applies an effect on a unit (set effect to set several effects ) but if i create a periodic event the unit itself is the centre of the force.
 
Level 9
Joined
Dec 21, 2006
Messages
490
"You must not have the source and target for the effect set properly."

how do you mean that? i mean what exactly shall i do there then...
----------------------------
my problem is, i need a point with offset in direction to the attacking unit where the centre of the force effect should be. or the centre itself is the attacking unit with huge radius BUT i have no clue how to apply an effect on the attacking unit itself + effect on the attacked unit on the same weapon. ( and the force effect applied on the attacking unit needs validating the attacked unit somehow...)
i found a solution with triggers but hell the data editor must be able to handle this.
 
Last edited:
Status
Not open for further replies.
Top