3 questions

[beti91]

Hello!

I have few questions. I not found satisfactory answers.

1.) It's possible to upload Starcraft 2 Arcade Warcraft Models to Warcraft 3? If so, how to do it? I can't find any single tutorial in internet.

2.) It's possible to replace some model e.g Wacraft 3 Sylvanas model on just any model from e.g WoW BUT so as to THIS NEW MODEL from WOW had old animations from Warcraft 3 Sylvanas? How to do it?

3.) In custom "Heroes Return" I saw nice thing but i dont know any tutoial about it. How I can do "spell casting" effect (like in WoW) i mind loading of spells. not channeling

Please help. I tried to combine itself because I could not find guides. all for nothing.

Thank you.

 

[Nichilus]

1) Doubt you can. AFAIK SCII models are far more complicated and far larger in file size than WCIII models. If you were planning to put SCII's model into multiplayer WCIII map, then do note that multiplayer WCIII maps have iirc an 8mb file size limit to be playable on battle.net (dunno if this limit applies to other sites)

2) No. If anything, this would require the whole model to be remade, which basically means you make the model from scratch anyway.

3) Dunno what map that is, but I think it's a mix of an unselectable unit that has the progress bar model or something similar to simulate the progress bar over unit's head.

 

[beti91]

1. I want that models to the campaign. I stuck in point: I know how exported model in file format .m3 but i dont know how load that model to the Warcraft's editor.

2. thanks for answer but this sad news for me

3. I was wrong. Name of that lvl is "WoW: Battle of Azeroth" by Reyzu. later I put here a screenshot and show you exactly what I mean.

 

[Dr Super Good]

1.) It's possible to upload Starcraft 2 Arcade Warcraft Models to Warcraft 3?

Yes it is.

If so, how to do it?

Use (write) a converter between M3 and mdx. It will need to discard a lot of SC2 data that is not supported by WC3.

I can't find any single tutorial in internet.

No one cares much about SC2.

2.) It's possible to replace some model e.g Wacraft 3 Sylvanas model on just any model from e.g WoW BUT so as to THIS NEW MODEL from WOW had old animations from Warcraft 3 Sylvanas? How to do it?

Yes it is possible. You just need to import both into a model editor, delete the WoW model's bones and replace them with new ones. Probably need to be fairly good with model editors. In the end you will need to import the meshes, bones and animations as a single mdx file so one might as well use the WoW animations if one can to.