trigger choke

[doom_sheep]

when I made a 300 loop that had a loop inside it (to make a lot of trees) it just stopped halfway. debug messages reveal that it just stops running at some point.

is there knowledge of what causes this? I still need to place those trees and would like to know what limit I need to bypass. for example, is it just too many lines in one trigger or too many in a too small time frame?

 

[IcemanBo]

Hm, you may hit the operation limit of one thread. Could you post your trigger please?

 

[deathismyfriend]

I would also think you are hitting op-limit. Try splitting the triggers up / or use a wait after every loop.

 

[doom_sheep]

so it's just that the trigger itself is too long? splitting it into others that run at the same millisecond would be fine then?

 

[deathismyfriend]

Yes it would be fine. It could also be an error though. Showing us the trigger would be your best bet to finding the right answer.

Also something to note that triggers never run at the same time. Warcraft 3 runs one trigger then the next.

 

[doom_sheep]

the trigger's long gone. I've had it happen before, though.