- Joined
- Jun 13, 2008
- Messages
- 102
Does anyone have any ideas how I could pick the weakest unit in an area?
-
🏆 Texturing Contest #33 is OPEN! Contestants must re-texture a SD unit model found in-game (Warcraft 3 Classic), recreating the unit into a peaceful NPC version. 🔗Click here to enter!
Pick Weakest Unit
- Status
Spell Reviewer
- Joined
- Jan 18, 2005
- Messages
- 27,202
Firstly by difining what weak means.
If you mean lowest approximate duribility then you use the simple minimum algerthim for on the sum of health and shield for all units to select from.
Basically if there is 1 or more valid units to effect, get the first one and then note it as the lowest. The compare the second (if one exists) to the lowest and if it is lower, make it the lowest. Repeat until all units are checked and you will have your lowest.
If you mean lowest approximate duribility then you use the simple minimum algerthim for on the sum of health and shield for all units to select from.
Basically if there is 1 or more valid units to effect, get the first one and then note it as the lowest. The compare the second (if one exists) to the lowest and if it is lower, make it the lowest. Repeat until all units are checked and you will have your lowest.
- Joined
- Jun 3, 2010
- Messages
- 100
In the Unit data, you can set the Attack Target Priority, so just set them accordingly for your units. This is assuming you are not talking about what DSG explained.
- Status
