- Joined
- Jun 13, 2008
- Messages
- 102
Does anyone have any ideas how I could pick the weakest unit in an area?
-
Listen to a special audio message from Bill Roper to the Hive Workshop community (Bill is a former Vice President of Blizzard Entertainment, Producer, Designer, Musician, Voice Actor) 🔗Click here to hear his message!
-
Read Evilhog's interview with Gregory Alper, the original composer of the music for WarCraft: Orcs & Humans 🔗Click here to read the full interview.
Pick Weakest Unit
- Status
Spell Reviewer
- Joined
- Jan 18, 2005
- Messages
- 27,290
Firstly by difining what weak means.
If you mean lowest approximate duribility then you use the simple minimum algerthim for on the sum of health and shield for all units to select from.
Basically if there is 1 or more valid units to effect, get the first one and then note it as the lowest. The compare the second (if one exists) to the lowest and if it is lower, make it the lowest. Repeat until all units are checked and you will have your lowest.
If you mean lowest approximate duribility then you use the simple minimum algerthim for on the sum of health and shield for all units to select from.
Basically if there is 1 or more valid units to effect, get the first one and then note it as the lowest. The compare the second (if one exists) to the lowest and if it is lower, make it the lowest. Repeat until all units are checked and you will have your lowest.
- Joined
- Jun 3, 2010
- Messages
- 100
In the Unit data, you can set the Attack Target Priority, so just set them accordingly for your units. This is assuming you are not talking about what DSG explained.
- Status
