[General] Fast Way to Convert all GUI triggers to JASS

[tulee]

Searched through hive looking for a similar answer but could not find any answer that matched this question.

Was just wondering if there is a faster way to convert all GUI triggers in a map/campaign than by right-clicking each individual one and converting to custom script.

If not no problem, was just curious. Thanks~~

 

[millzy]

there would be no point in doing this unless u are planing to edit after converting to custom script.

i dont believe there is a way to do multiple at a time either

 

[tulee]

Ah ok, good to know. Thanks millzy.

 

[Chaosy]

Yeah JASS is only faster if you write it from scratch, because GUI converted to JASS is so horribly bad just editing a few lines would not be nearly enough.

 

[Dr Super Good]

Yeah JASS is only faster if you write it from scratch, because GUI converted to JASS is so horribly bad just editing a few lines would not be nearly enough.

However doing it for speed reasons can be considered micro optimization. It only really makes a difference after algorithmic improvements at bottlenecks are depleted.

 

[Chaosy]

Maybe. Just swapping out certain BJ functions can save a whole lot of function calls.

But I get you, restructuring an if then else does not do much performance wise. It just makes it look less like a mess.