Listen to a special audio message from Bill Roper to the Hive Workshop community (Bill is a former Vice President of Blizzard Entertainment, Producer, Designer, Musician, Voice Actor) 🔗Click here to hear his message!
I basically need this texture exported and made into its own model so i can place it in any map terrain type without being limited to the cliff type of the given terrain type my map is. I'll need the model to work in all directions because ill use Slide Natural Cliff (East) and north, west, south as well.
I'd like it to look pretty much as close to the normal wc3 terrain as possible with the snow on the top and bottom as well.
Keep in mind i need this to work in older version like 1.28.5 as well as reforged. thanks!
The picture above was a good attempt from a friend that isnt really a modeler and its not quite when i need, also when i stack them side by side the snow looks like its cracked and when you look at it under fog of war when a unit isnt close by it looks black ridged and not good. He referenced some texture within wc3.
You don't need any custom models to do this since standard cliffs are already models. You only need to import the Northrend cliff texture (attached below) so it doesn't get replaced depending on the tileset.
You might need to use a lot of destructibles since each variation of each side and each corner is a separate model (paths below).
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
