• Listen to a special audio message from Bill Roper to the Hive Workshop community (Bill is a former Vice President of Blizzard Entertainment, Producer, Designer, Musician, Voice Actor) 🔗Click here to hear his message!
  • Read Evilhog's interview with Gregory Alper, the original composer of the music for WarCraft: Orcs & Humans 🔗Click here to read the full interview.

cliff level

  1. HerlySQR

    [General] Problem with calculus

    Why I will ask is a bit complicated, so I'll try to explain myself as best I can. I made a spell to push a unit to a point (like force staff) but if there is a wall of height 2 in the middle of the road then the unit stops, I wanna aplicate this also with platforms, if in the middle of the road...
  2. Branmatey

    Raised Cliff issues.

    Hi all. New to the world editor, and to Hive. I'm trying to create a waterfall, following a specific guide that mentions using the raise 2 tool twice, and then shallow water on the top layer. However, when I use the shallow water tool, it automatically punches through all cliff to the ground...
  3. Rektis

    [General] Raising cliff level and repositioning of entire map

    I started on cliff level 2 and this turns out to be way too low. I wish I had started on cliff level 4 or 5. Q1: Is there a way to raise the cliff level of the entire map, without removing anything like doodads or water? Solution: Use "Adjust Cliff Levels" in the Advanced tab. (Problem...
Top