Need help for use the models

[killer702]

It's write, how use a models plz? i download 4 models but i don't know for use it. ( for a Rpg )

 

[Lord_T]

Hello, welcome to the hive workshop. We tend to speak english on this board, and your compliance would be helpful.
Anyway, to use a model downloaded from the resources section, you usually just
need to import them and remove the war3imported\ from in front of the texture.
Then assign the model to a unit\item.

 

[TheDivineBoss]

Download, unpack with .rar like into C:\Program Files\Warcraft III\Model Map, that's what I have to dump my models somewhere and then go to World Editor, Import Editor, import all in that map and delete the ReadMe, no one reads ReadMe's and delete yes the war3imported\ away from it, save the map, restart WE and go to like Object Editor, make your unit and to go Model thinger, you see then the middle tab is available (there are the imported models) and now you can use those models.

With skins it's a other story, ask someone else for that.

 

[killer702]

Thanks all, i can continue my rpg now.

 

[N8-11_GER]

why u have to restart we?....

 

[TheDivineBoss]

Or else the just imported models won't work.

 

[killer702]

N8-11, why you say that? restart what?

 

[TheDivineBoss]

World Editor, restart WE (look at beginning) when you imported (all) your models so they can be used.

 

[N8-11_GER]

without restart i could use 10% with restart 80% but not all :'(

 

[TheDivineBoss]

Hey, before you go ask question, I'm just a average WE-user (but not a modeler nor triggerer) and I'm not thát good at it, ask like Steel_Stallion or some other mapmaker.

 

[N8-11_GER]

wasnt a quest was a fact^^ sry for missunderstood

 

[Kuhneghetz]

N8-11, why you say that? restart what?

You simply save the map, quit WE and then re-open the program with the map.

 

[donut3.5]

You have to save the World Editor because it has not loaded the newly imported models and skins in yet, so by simply saving it will load them. However if you attempt to view the skins/models before saving, then you will have to save and restart WE for it to properly load them.
--donut3.5--

 

[TheDivineBoss]

[Long silence]

...

Uh... Yeah.. You can get the chance to see them (instead of purple blocks) without restarting WE...

I think...

I only had that (problem) few times, though...

....

 

[KenshinUesugi]

Take note, some models require special pathing other then just deleting the war3import/ For example all of Black_Stan's texture pathings have textures/ in front of .blp files. Check the model's page were you got it if there is any special custom pathing needed for the said model. That is probably why you're not getting a 100% in working models. That or the resource mods approved a defuctional model >.>