Sasuke_1000UXD
S
Sasuke_1000UXD
please, help me, i got all this models here, but can't apply them, applied the paths still nothing, waaaaaaaaaaaaaaaaaaaaaah
-
Listen to a special audio message from Bill Roper to the Hive Workshop community (Bill is a former Vice President of Blizzard Entertainment, Producer, Designer, Musician, Voice Actor) 🔗Click here to hear his message!
-
Read Evilhog's interview with Gregory Alper, the original composer of the music for WarCraft: Orcs & Humans 🔗Click here to read the full interview.
-
The Hive's 22nd Icon Contest: Creep Abilities is now concluded, time to vote for your favourite set of icons! Click here to vote!
-
✅ The POLL for Hive's Texturing Contest #34 is OPEN! Vote for the TOP 3 SKINS! 🔗Click here to cast your vote!
-
✅ The POLL for Hive's Techtree Contest #20 is OPEN! Vote for the TOP 3 FACTIONS! 🔗Click here to cast your vote!
Help me in importing
- Status
- Joined
- Apr 3, 2009
- Messages
- 83
Can you explain exactly what goes wrong when you import them to the map and how you are doing it, in every detail, please. That would spread some light over what goes wrong, since your description of this problem doesn't tell me anything.
(And I can also find those models on hive, so I supose it isn't their fault that it isn't working).
(And I can also find those models on hive, so I supose it isn't their fault that it isn't working).
- Joined
- Jan 26, 2007
- Messages
- 4,787
These are the paths:
I hope next time you will either read the readme (that's why it's called "readme"
) or check the texture paths.
If this didn't work out, there's always a tutorial about this right above the "download model"-link.
It says: Not sure how to import this model? Click here
- RPGElf.mdx
- Textures\RPGElf.blp
- Vampireknight.mdx
- CloudStrife.mdx
- CloudStrife_by_kitabatake.blp
I hope next time you will either read the readme (that's why it's called "readme"
) or check the texture paths.
If this didn't work out, there's always a tutorial about this right above the "download model"-link.
It says: Not sure how to import this model? Click here
Dr Super Good
Spell Reviewer
- Joined
- Jan 18, 2005
- Messages
- 27,354
You must import the models.
Change their paths to be correct.
Save the map.
Close WE and WC3 (not just exit map but physically turn the program off).
Open your map again (double click your map).
Your models should now work, if not you messed up the pathing step or the models are broken.
Change their paths to be correct.
Save the map.
Close WE and WC3 (not just exit map but physically turn the program off).
Open your map again (double click your map).
Your models should now work, if not you messed up the pathing step or the models are broken.
- Joined
- Jan 26, 2007
- Messages
- 4,787
Saving/closing the map and opening it again works for me
Well, it might not work for everyone though
(the general idea I went by is that the models need to be loaded, so you need to re-load the map, physically turning off the program isn't necessary for that).Well, it shouldn't matter that much, as long as it works >.>
- Status
