• Listen to a special audio message from Bill Roper to the Hive Workshop community (Bill is a former Vice President of Blizzard Entertainment, Producer, Designer, Musician, Voice Actor) 🔗Click here to hear his message!
  • Read Evilhog's interview with Gregory Alper, the original composer of the music for WarCraft: Orcs & Humans 🔗Click here to read the full interview.
  • The Hive's 22nd Icon Contest: Creep Abilities is now concluded, time to vote for your favourite set of icons! Click here to vote!
  • ✅ The POLL for Hive's Texturing Contest #34 is OPEN! Vote for the TOP 3 SKINS! 🔗Click here to cast your vote!
  • ✅ The POLL for Hive's Techtree Contest #20 is OPEN! Vote for the TOP 3 FACTIONS! 🔗Click here to cast your vote!

Adding Water without using cliff tool?

Status
Not open for further replies.
You have to create your map so all of it is one of the two initial cliff water depths, then use the raise tool to raise everything up (usually just raise a spot up then plateau it across the map so its smooth) and then whenever you use the lower tool to lower the ground deep enough (depending on how high you raised it before) you will strike pay dirt... i mean water.
 
Status
Not open for further replies.

Similar threads

Zelda95
  • Locked
[Solved] Water without cliffs?
Replies
6
Views
1K
Nichilus
Nichilus
Yiux
  • Locked
Cliff levels
Replies
5
Views
3K
MeKC
MeKC
Death_Rift
  • Locked
Island
Replies
2
Views
1K
Adiktuz
Adiktuz
Lambdadelta
  • Locked
[General] Workflow?
Replies
3
Views
1K
Drake53
Drake53
L
  • Locked
[General] NEW TO EDITOR | How do I get rid of these water based cliffs?
Replies
0
Views
762
lukeleppin
L
Back
Top